0032 Components of the Outer Registers

Regarding the Midsection of the "Video Interface" shown in my last Post...

The Component I showed can also be used in these Locations also.

and

But when the "Video Interface" is using this Format or Mode.

By using both Dotted lines (Broken Line Work which is mobile) and Static Line Work
we can create different functions.

or

The layout is presented this way, because the Center Section ("Square") is the area
where the "Importing" and "Editing" takes place.
In other words the "Outer" is the Source of the Main "Temporary Libraries".

The Center Section, is also divided into 2 "Rectangles", forming like an "Open Book"
with Left and Right "Pages", during some functions.

We can also find (By "Rotating" the book) an Upper and Lower "Page".

This now leaves the 2 "Outer" Rectangular "Partitions" which are the 2 "Outer" Pages.
This is the Source i.e. The Main "Temporary Libraries" a Copy of the contents
found in One of the "Permanent Libraries".

These 2 Pages can also be "Partitioned" into Upper and Lower "Partitions".

and in these "Partitions" we find "The 9 Gates" once again.

Note the Registers in "The 9 Gates" the YELLOW Line Work Passes through.

These are some of the "Positions" the Larger Octagonal Registers can be found in.
The "Octagonal Registers" display Commands. These are only a few of the Letters
or Glyphs out of thousands.

And their other Corner Locations.

And the 5th Location, the "Primary Accumulator".

There are also a number of "Inner" Octagonal Registers in the outer Registers
using smaller "Instruction" Glyphs or Letters.

6 of these 12 Registers form a Vertical Set. (the Register enlarged)

and the other 6 Registers form a Horizontal Set.

The Geometric "Instruction" for this Set of "Inner" Octagonal Registers
is an "Octagonal Frame" on its side shown here in MAGENTA.

There is another Set of 12 small Octagonal Registers about a Common "Primary
Accumulator". (a Total of 13 Octagons)

Here are the 4 Subsets, displayed Individually.

First the Program Register "9 Gates".

Second the Control Register "9 Gates".

Thirdly the Scratch Pad Register "9 Gates"

And lastly the Picture Register or Data Register.

In my next Post I will reveal more regarding the "Temporary Hexagonal"
Shaped Registers and its sub Registers.


NOTE;
To gain the full understanding, please Start this "Thesis" from the beginning at 0001
if you haven't already...